A driveway that greets guests with deep color
Driveway Paver Sealing in Sawgrass, FL
Call (904) 606-1450 for a free quote and a sealed paver driveway with full joints.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Who seals paver driveways in Sawgrass, and how soon will they call?
A local contractor takes paver driveway jobs across Sawgrass, FL, and the reply to your request comes inside 1 business day, usually the same day. The quote is free and signing is your choice. To start, call (904) 606-1450.
The driveway is the first thing a guest sees and the spot every visitor parks on. Tires, oil drips and hours of open sun all land there, so the color goes chalky first and the joints sag first. A clean, sand and seal brings both back. Send the width, the length and any oil spots when you request your free estimate, and the first answer can include a ballpark.
What do tires and oil do to a paver driveway?
Rochester Concrete Products lists grease and oil among the common stains and points to degreasers for them. Brickworks, an Australian brick maker, adds that hot pavers stain more easily, which is what a sunny drive is after a long afternoon. That is why the stain treatment comes before the wash and the coat.
Sealer on top of an old oil spot locks the shadow in. A clean surface comes first, because Brickworks warns that sealer can make existing stains more visible. Point out your garage apron and parking spot when you call (904) 606-1450.
Does my Sawgrass driveway need sealing, or can it wait?
Unilock says its driveway and patio pavers do not need a sealer to perform, so the choice is yours. Rochester Concrete Products says sealing can pay off in high exposure spots such as driveways, and also that it adds cost and needs a redo every so often. A driveway that has never been sealed can still be restored, according to a St. Johns County paver company.
Wait if the pavers are tight, the color is even and rain beads on the surface. Seal if the surface drinks water, the joints keep losing sand or oil shows up each time. To ask a contractor which camp you are in, request your free estimate.
What if my driveway has sunk, lifted or lost sand?
Sealer cannot raise a low paver or close a gap, and Unilock says sealing does not correct drainage or base problems. A local paver company lists oak roots lifting pavers and settled driveway aprons as common problems, and puts leveling and re-basing at about $8 to $20 per square foot.
When joints are empty or an old coat has failed, a Northeast Florida washing company calls it a two day restoration, since the surface must dry between steps. Ask whether leveling sits inside the quote or apart from it when you call (904) 606-1450.
How should a driveway be washed without emptying the joints?
Gently. Rochester Concrete Products warns that too much pressure damages joint sand, and Unilock suggests a fan nozzle at a 30 degree angle about 12 inches from the surface. A surface cleaner keeps the pass even, and fresh sand goes in afterward.
After the wash, the pavers need to dry. Unilock says a few hours in warm sun or about 24 hours in shade. Ask what tools the contractor plans to use when you request your free estimate.
Wet look or matte for a driveway?
A wet look film deepens the color and adds shine. Rochester Concrete Products says topical sealers like that wear down under sun, traffic and pressure washing, and that a penetrating sealer leaves little gloss and keeps a natural look. Unilock adds that high gloss gets slippery when wet.
For a sloped drive or a front walk beside it, matte is the safer pick. For a rich red or charcoal that shows up from the street, the wet look earns a second look. Ask to see both on a sample paver when you call (904) 606-1450.
Can the edges near the lawn and sprinklers be protected?
Yes. Unilock suggests a flat metal sheet along edges and structures, because sealer does not wash off once it lands. Sprinklers need to stay off too, since water can leave white marks or get trapped under the coat.
St. Johns County sets watering days by address: in daylight saving time odd numbers water Wednesday and Saturday, and even numbers Thursday and Sunday. Pick a job day that is not one of yours, and ask the contractor to check your heads for spray onto the drive. Mention the zones when you request your free estimate.
What does a paver driveway sealing job cost in Sawgrass?
Two published pages set the numbers. A Northeast Florida washing company lists $1.75 to $3.25 per square foot to clean, sand and seal. A St. Johns County paver company breaks the job into steps, from $0.30 for cleaning alone to $3.50 for stripping and a full restoration. No page prices a driveway alone at one rate, so the table builds an 800 square foot driveway from those pieces.
A bid far under these ranges usually skips steps, so ask what each line covers. To price your own driveway, request your free estimate.
| Job | Published rate per sq ft | 800 sq ft driveway |
|---|---|---|
| Cleaning only | $0.30 to $0.50 | $240 to $400 |
| Clean and re-sand | $0.75 to $1.00 | $600 to $800 |
| Clean, sand and seal (one local company) | $1.75 to $2.50 | $1,400 to $2,000 |
| Clean, sand and seal (wider range) | $1.75 to $3.25 | $1,400 to $2,600 |
| Strip old sealer and restore | $2.75 to $3.50 | $2,200 to $2,800 |
Published rates. The same paver company puts a 1,000 to 1,500 square foot driveway at about $1,750 to $3,750 for the complete job. The contractor names the real price once the surface has been seen.
How long until I can park on it again?
About 48 hours for vehicles, says a St. Johns County paver company, and Unilock lets the coat cure for up to 48 hours of dry weather. Feet can usually return after about 24. Move the cars before the job starts, and ask the contractor how long a garage door apron must stay clear. To set a date, call (904) 606-1450.
How often should a Sawgrass driveway be resealed?
Every two to five years. The washing company says two to three is typical, and Unilock says three to five. Rochester Concrete Products notes that even sealed pavers keep taking some UV damage. A driveway in open sun, with tires on it daily, belongs near the short end. To plan yours, request your free estimate.
Does an association review a driveway finish in Sawgrass?
Many homes here sit inside the gated communities that Wikipedia describes, the TPC Sawgrass Players Club and Sawgrass Country Club. Florida Statute 720.3035 says a board may review only what its documents state or reasonably imply, must apply the rules equally and must name the rule in a written denial. A driveway faces the street, so ask whether a color change or a shiny finish needs a notice. Get a start date and product name from the contractor by calling (904) 606-1450.
Which neighborhoods near Sawgrass can get driveway sealing?
A free quote is open to Sawgrass and to every place listed here, each with a page of local notes. If your street is missing, call (904) 606-1450.
What do sealed paver driveways look like around Sawgrass?
What is the driveway sealing process from first look to finished coat?
The process has five parts, and the order matters. To get on the calendar, call (904) 606-1450.
- Measure and photograph. The contractor walks the drive, notes sunken spots, oil, old sealer and where water runs, and sets the square footage.
- Treat the stains. Oil, rust and algae each get a cleaner meant for that stain, before any wash.
- Wash at low pressure. Too much force empties the joints, so the surface cleaner runs gently.
- Repair and refill. Low or lifted pavers are reset, then dry joints are filled with fresh sand.
- Seal and block off. The coat goes on a dry drive in one session, and cars stay off until the contractor says they can return.
Why hire a local contractor for a Sawgrass driveway?
A contractor who works nearby already plans around summer storms, oak roots and gated entrances. The price is written down and the choice stays yours. To begin, request your free estimate.
Frequently Asked Questions
Is it good to seal pavers in Florida?
On a driveway it often is. Sun fades color, storms wash sand from the joints and tires leave marks. A Northeast Florida washing company says full sun pushes a reseal toward two years, and Rochester Concrete Products, a paver maker, names driveways as a high exposure spot where sealing can pay off. To see if yours qualifies, call (904) 606-1450.
How long do paver sealers last?
Two to five years is the working range. The washing company calls two to three typical, and Unilock says three to five. A driveway that takes full sun and daily tires sits near the short end. Dark patches where water soaks in mean it is time. To book a check, request your free estimate.
How much does it cost to have pavers cleaned and sealed?
Published local rates run $1.75 to $3.25 per square foot for the whole clean, sand and seal. A St. Johns County paver company puts a 1,000 to 1,500 square foot driveway at about $1,750 to $3,750 for the complete job. Old sealer that must be stripped raises the price. To price your drive, request your free estimate.
What is a good material for a driveway in Florida?
No page read for this site ranks driveway materials, so there is no fair winner to name. Pavers are what this page covers, and Unilock says its patio and driveway pavers do not need a sealer to perform, so sealing is a choice about looks and upkeep. For a view on your driveway, call (904) 606-1450.
How long before I can drive on a newly sealed driveway?
A St. Johns County paver company says about 48 hours before vehicles, and Unilock allows up to 48 hours of dry weather to cure. Plan where the cars will sleep for two nights, and ask about the weather window. To set the date, call (904) 606-1450.
Can a sunken or lifted driveway be fixed before sealing?
Yes, and it should be. Sealer cannot raise a paver or close a gap, a point Unilock makes plainly. The same local company lists leveling and re-basing at about $8 to $20 per square foot. Show the contractor the low spots when you request your free estimate.
Does an association need to approve a new driveway finish in Sawgrass?
It may. Florida Statute 720.3035 says a board reviews only what its documents state, applies the rules evenly and must name the rule in a written denial. A driveway faces the street, so it is the part of a home any board can see. To get the product name and finish in writing for them, call (904) 606-1450.
What happens if it rains on the day of my driveway job?
The job moves. Unilock asks for 24 to 48 hours of clear skies before and after sealing, with temperatures between 50 and 90 degrees. A Northeast Florida washing company calls fall the drier season for sealing. Ask how the contractor handles a washed-out date when you request your free estimate.
Want the driveway to look new when guests pull in?
Call or fill in the short form, and a contractor writes back inside 1 business day, typically within hours.
Free, no obligation